Key takeaways
- Getting the water off is the single most valuable thing a caller can do before the technician arrives, and a calm CSR can usually guide them to it in a few minutes.
- Start with the nearest fixture valve, then the main. Only move to the curb stop if your local rules allow homeowners to use it.
- Set boundaries: no standing in water near electrics, no climbing into unsafe crawl spaces, no touching gas controls.
- Water damage and freezing caused 22.6% of US homeowners insurance losses in 2023[1], which is why every CSR should know this script by heart.
Why the shutoff call matters
When water is pouring from a burst pipe or a failed supply line, every minute adds to the damage. A technician may be thirty minutes or more away. The caller, however, is standing in the house. If your CSR can help them close the right valve in the first few minutes of the call, the job changes from a flood to a repair.
Source: Insurance Information Institute, 2023[1]
Show the data
| Item | Value |
|---|---|
| 2019 | 28.7% |
| 2023 | 22.6% |
Water damage and freezing are a large and persistent share of home insurance losses: 28.7% in 2019 and 22.6% in 2023[1]. You will take these calls every week, and more of them in a freeze.
Safety boundaries before anything else
Before you guide anyone to a valve, the CSR should say three things:
- "If water is near outlets, the electrical panel or appliances, please stay out of that area." Never ask a caller to reach a panel or a valve while standing in water near electrical equipment.
- "Don't go anywhere you can't get to safely." Flooded basements, unlit crawl spaces and attic hatches above a wet ceiling are not places to send someone over the phone.
- "If you smell gas at any point, leave the house and call 911 and your gas company from outside." Then end the shutoff guidance.
If the caller cannot reach the valve safely, the right decision is to dispatch now and tell them how to protect themselves and their belongings until the technician arrives.
Step 1: try the nearest fixture valve
Most leaks under sinks, behind toilets and at washing machines can be stopped with the small valve on the supply line.
"Is the water coming from under the sink, behind the toilet or from the washing machine? ... Look on the wall or floor just below it. You should see a small handle or oval knob on the pipe. Turn it to the right, clockwise, until it stops."
If the handle is stiff, tell the caller not to force it with a wrench. Old fixture valves can snap. Move straight to the main.
Step 2: find the main shutoff
Ask where the water comes into the house. The main shutoff is usually within a few feet of where the supply pipe enters.
| Home type | Most likely places | Prompt for the caller |
|---|---|---|
| House with basement | Front wall of the basement, near the water meter | "Go to the basement wall that faces the street and look low down for a pipe coming through." |
| House on a slab | Garage, utility closet, near the water heater, or an outside wall | "Check the garage and the water heater closet for a valve on the incoming pipe." |
| Crawl-space home | Just inside the crawl-space access, or at an outside hose bib wall | "Look near the crawl-space door before going in. Don't crawl in if it's wet or dark." |
| Warm-climate homes | Outside, on the wall where the pipe enters, or in a ground box | "Look outside on the side of the house facing the street." |
| Apartment or condo | Under the kitchen sink, in a utility closet or behind an access panel; sometimes only the building can shut it | "Call your building manager or maintenance line at the same time." |
If the caller has a smartphone, ask them to describe what they see or send a photo. Pew Research Center reports that 91% of US adults own a smartphone[2], so a quick photo of the valve or the meter area is usually possible.
Step 3: close it the right way
There are two common types of main valve, and they close differently:
- A lever (ball valve): a flat handle. Turn it a quarter turn so the handle is across the pipe, not along it.
- A round wheel (gate valve): turn it clockwise, to the right, until it stops. It may take several turns. Older gate valves can be stiff; firm hand pressure is fine, but forcing it with tools can break the stem.
"Turn the handle to the right until it stops. Tell me when you've done it, and then we'll check the leak."
Step 4: confirm the water is off
"Now go back to where the leak was. Is it slowing down or stopped?"
Then ask the caller to open the lowest faucet in the house, such as a basement or ground-floor tap, to relieve pressure and drain the water still in the pipes. That reduces how much more water escapes from the leak.
If the water heater is the source, ask them to close the cold-water valve on the pipe at the top of the heater. Do not ask callers to touch gas controls, relight pilots or open the heater's drain valve.
Step 5: the curb stop, only if allowed
Some homes have a second shutoff at the property line, in a ground box near the street. It usually needs a special key, and in many areas it belongs to the water supplier. Know your local rules: if homeowners are not supposed to operate it, tell the caller to call the water supplier's emergency line instead, and dispatch your technician now.
Step 6: protect the house while they wait
- Move valuables, rugs and electronics away from the water.
- Put towels or buckets under drips.
- If a ceiling is sagging with water, keep people out of the room below it.
- Take photos of the damage for insurance.
- Keep the phone nearby so the technician can call on the way.
The household's leaks, small and large, add up: the average household wastes more than 9,300 gallons of water a year through leaks[3]. After an emergency is a good moment to offer a full leak check as well as the repair.
When the caller panics
Some callers are too distressed to follow instructions at first. That is normal, and the CSR's tone matters more than the words. Slow down, lower your voice slightly and give one instruction at a time.
"OK. I'm going to help you stop the water. First, is anyone hurt? ... Good. Now, can you see where the water is coming from?"
Use the caller's name once you have it. Ask them to describe what they see rather than asking yes-or-no questions they may not be able to answer. If they keep returning to the damage, acknowledge it briefly and bring them back to the valve: "I know, that's awful. Let's get the water off first, and then we'll deal with the rest."
If the caller cannot calm down enough to look for the valve, stop trying. Confirm the address, dispatch now and give simple protective steps instead. A technician on the way is better than a caller wandering through a wet house looking for a valve they cannot find.
Freezing weather calls
In a cold snap, add a question about frozen pipes. Pipes freeze most often when exposed to severe cold, in unheated spaces such as basements, crawl spaces, attics, garages and kitchen cabinets, or against uninsulated outside walls[4].
If a pipe is frozen but not leaking, tell the caller where the main shutoff is before anything thaws, so they are ready if it bursts. Advise against open flames for thawing. The American Red Cross advises keeping the heat set no lower than 55 F when you are away in cold weather[5], which is useful advice to give callers once the emergency is under control.
Example: a calm shutoff call
Example: a fictional caller in a 1960s ranch house calls at 6:45 am. A supply line under the bathroom sink has burst and water is spreading into the hall. The CSR asks whether water is near any outlets; it is not. The fixture valve is stiff, so the CSR moves to the main.
The house is on a slab. The caller checks the garage and finds a round wheel valve next to the water heater. The CSR tells them to turn it clockwise until it stops. It takes five turns. The water slows within a minute. The CSR asks them to open the kitchen tap to drain the lines and to put towels down in the hall. Example: the call takes six minutes, and the technician arrives to a wet floor rather than a flooded hall.
Train the script
Give every CSR a copy
Print the six steps on one card at each desk and in the after-hours phone.
Practice with photos
Show CSRs pictures of gate valves, ball valves, meters and curb boxes so they recognize what callers describe.
Role-play the hard cases
A panicking caller, a stiff valve, an apartment with no access, water near the panel.
Review real calls
After any shutoff call, listen back to see where the caller got stuck.
Encourage customers to label valves
Offer to tag the main shutoff on every service visit, so next time the caller knows exactly where it is.
Frequently asked questions
Which way do you turn a water shutoff valve to close it?
Turn a round wheel valve clockwise, to the right, until it stops. Turn a lever valve a quarter turn so the handle sits across the pipe.
Should a CSR ask a caller to use the curb stop?
Only if your local water supplier allows homeowners to operate it and the caller has the right key. Otherwise, tell them to call the water supplier's emergency line and dispatch a technician.
What if the caller cannot find the main shutoff?
Treat it as a dispatch-now emergency. Help them protect belongings, keep away from electrics and wait for the technician. A photo from their phone can sometimes help you spot the valve.
Should the caller turn off the water heater?
They can close the cold-water supply valve at the top of the heater. Do not ask callers to adjust gas controls or relight pilots over the phone.
References
Insurance Information Institute (2023). Facts + Statistics: Homeowners and renters insurance (opens in a new tab) โ
Pew Research Center (2026). Mobile Fact Sheet (opens in a new tab) โ
U.S. Environmental Protection Agency, WaterSense (2026). Fix a Leak Week (opens in a new tab) โ
American Red Cross (2026). Frozen Pipes (opens in a new tab) โ
American Red Cross (2026). Frozen Pipes (opens in a new tab) โ